How to remove or attach the integrated mount depends on your device. Find your device and the relevant instructions below:
GO 400, GO 40/50/60, START 40/50/60
To remove the integrated mount of your device, watch the video or follow the step-by-step instructions below.
Watch the video
Step-by-step instructions
-
Lift the mount, then push the button in the direction of the mount.
-
Pull the mount out of the device until it is detached.
To re-attach the mount to the navigation device, place the mount into the slot (from either side) and slide it in.
GO 800 series, Via series, Start 20 series
If you want to remove or attach the integrated mount of your device, watch the video or follow the step-by-step instructions below.
Watch the video
Step-by-step instructions
-
Lift the mount and rotate it 90 degrees.
-
The ball has a groove in it as shown below.
-
To remove the mount, gently push the groove in the ball against the edge of the socket. This levers the mount out of it’s socket by pushing it to the LEFT in the images shown below.
Tip : In step 1, you can rotate the mount by 90 degrees in either direction, left or right. You just need to remember to push the ball out of the joint towards the direction of the groove.
To re-attach the mount to the navigation device, place the ball over the socket and reverse the steps.